Ask Experts Questions for FREE Help !
Ask
    Beksavannah's Avatar
    Beksavannah Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 28, 2013, 05:08 PM
    Fan control on 2000 Nissan Frontier
    Fan on heater/airconditioner only works on high
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Aug 28, 2013, 06:40 PM
    Probably a bad resistor on the motor circuit. The fact that it works on high is an indicator. Go to Nissan Frontier / Navara Forum and search for your topic, tells you part number, location and how to change the resistor pack.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #3

    Aug 29, 2013, 06:28 AM
    Bad resistor, which may be part of the switch assembly.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to replace a thermal control amplifier on 2001 nissan frontier [ 0 Answers ]

I replaced a thermal control amp for my a/c on a 2001 nissan frontier. I put the TCA in with the "red tip" in the down position. Does this matter or does it need to be in the up position?

Where can I get a fule line for a nissan frontier 2000 [ 2 Answers ]

My 2000 nissan frontier keeps dying on me after about 20 minutes of running also the battery won't hold a charge

Will a 02-04 Nissan Xterra hood bolt right on a 2000 Nissan Frontier with no mods? [ 0 Answers ]

I've seen it done before online and in magazines. As far as I can tell comparing the two side by side; everything looks identical except the headlight cutouts which I intend to fill. I think it would add a bold custom look. Just wondering. Thanks for your time!

2000 Nissan Frontier (V6 3.3L) with Knocking Sensor Code Displayed [ 3 Answers ]

We have had a knocking sensor code triggered on our Frontier on Bank 1 Sensor 1 and Bank 2 Sensor 1. We replaced all 4 oxygen sensors (Bank 1 Sensor 1, Bank 2 Sensor 1, Bank 1 Sensor 2 and Bank 2 Sensor 2) and the knocking sensor code has been triggered once again. I have put in Denso sensors and...

'03 Nissan Frontier Misfire [ 1 Answers ]

I have 2003 Nissan Frontier w/ 4cyl. Auto. The engine shudders under light acceleration at low rpm. If I press the pedal on down or let off completely it seems to smooth out. I am getting a code for " cylinder # 1 misfire". I replaced plugs, wires, cap and rotor with no noticeable improvement. My...

View more questions Search