Ask Experts Questions for FREE Help !
Ask
    Steffanddave's Avatar
    Steffanddave Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 25, 2013, 11:02 AM
    Kenmore elite dw tripping breaker
    Had the Sears repairman here who replaced the control board then the outlet pump. Still tripping breaker after 1-2 loads. New guy came out and he discovered the wire from the house to Dw was hot on all three prongs (including the ground). Husband replaced wire from junction box to dw. No obvious breakage noted Ran a drain cycle then started a wash cycle. Ran for about 20-30" then tripped the circuit breaker. He took the cover off the breaker box and there is no obvious issues. Wiring is only 4 years old, dw is almost 6. Nothing has changed. Help!

Check out some similar questions!

Kenmore elite dryer kicks breaker out after 3 minutes [ 0 Answers ]

If I run my dryer with no heat on a timed cycle it runs great but if I use any heat cycle it heats up but throws the breaker after apx 3 minutes. Ant ideas?

Breaker Tripping [ 4 Answers ]

Hello, I'll try to be as detailed as can be. I understand how electric circuits work but do not have a lot of experience with troubleshooting them. The problem is a tripping breaker whenever I turn on the associated ON/OFF switch. The switch connects to a lightbulb fixture and another wire...

Breaker tripping [ 5 Answers ]

In my bathroom I had an old light on the wall that had an outlet on it and the switch was also right on it. I bought a new light and had to run a new wire for the switch for the light. Connected new light ran the new wire and hooked up a new switch. The switch is fine when I have the light on, but...

Gfci breaker + outlet in same circuit.breaker tripping [ 4 Answers ]

I have a gfci breaker for a bathroom and there is an additional gfci outlet in the bathroom on the same circuit. The breaker was tripping intermittently over the past week and now will not re-engage. Should I suspect a faulty breaker or is it better to troubleshoot the circuit first? The...

Breaker not tripping [ 3 Answers ]

Hello, I was trying to install a light fixture and when I was done connecting the wires, I lifted the fixture towards the ceiling to mount it and there was a spark and caused a black mark on the ceiling. Would that cause the breaker to trip? And should I be concerned about the wiring causing a...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.