Ask Experts Questions for FREE Help !
Ask
    robtnclark's Avatar
    robtnclark Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 17, 2013, 07:55 PM
    Installation single phase 600 amp elect serv panel
    How complicated is it to put a 600 amp service in my shop. It's not wired right now, but I'd like to have enough juice to run a welder or some machine shop equipment like a lathe or radial arm drill or maybe even a bridgeport style mill.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Aug 18, 2013, 02:47 AM
    Have a professional install a 3 phase if available. This is not a DIY project or even one for a handyman.
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #3

    Aug 18, 2013, 04:21 AM
    Why do you think you need a 600 Amp supply? Are you planning to run everything at once?

    To begin, is your shop located inside your home or in a separate stand-alone building?

    Also, usually a utility company will only allow one meter for a residence. Next , find out if your utility has a 600 amp service available for a residence!

    I strongly suggest that you contact a licensed electrician to do a load calculation to determine what size feeder you really need.
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
    		  
    #4

    Aug 18, 2013, 04:22 AM
    As Brian said this is a job for the pros.

    The first thing you will need is for the power to be brought to building by power company. After that an electrician can set panel box.

    Chuck
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #5

    Aug 18, 2013, 04:55 AM
    You need two things for a job like this:
    A phone and a checkbook.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can I install a 600 volt single phase circuit in a underfloor concrete raceway with l [ 1 Answers ]

Will the 2008 NEC allow me to install a 600 volt single phase circuit in an underfloor concrete raceway that also has lower voltage control cables if a plastic divider separates the higher voltage wires from the control cables?

How I know if my house use a single-phase or triple phase electric panel breaker? [ 10 Answers ]

I am trying to buy the "plug and save", but I do not know what kind of phase panel I do have... how can I check what is the one I have? Thanks!

What size conductor do I need with a 3 phase 600 amp service [ 1 Answers ]

I want to hook up a transfer switch via generator at my shop for when the power go's out what size conductor do I need from the switch back to the load center?

Safety regarding 600 amp (Single Phase ) service. [ 5 Answers ]

I have a Single Phase 600 amp service entering my basement below grade level and running into a CT cabinet. Above the cabinet is where the electric meter is located. I need to caulk behind the CT cabinet where the electric cables carrying the 600 amp service from the outside transformer are. Is it...

View more questions Search