Ask Experts Questions for FREE Help !
Ask
    travisaude's Avatar
    travisaude Posts: 2, Reputation: 1
    New Member
     
    #1

    Jul 11, 2013, 01:19 PM
    Roller being forced out of track when opening, why is this?
    Second roller from top keeps getting forced out of track when I open it, usually at the half open point
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
     
    #2

    Jul 11, 2013, 01:58 PM
    Is this on your snowmobile?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #3

    Jul 11, 2013, 01:58 PM
    Roller on what? This was posted under appliances. Garage door? Better explanation please.
    travisaude's Avatar
    travisaude Posts: 2, Reputation: 1
    New Member
     
    #4

    Jul 11, 2013, 09:06 PM
    Quote Originally Posted by ma0641 View Post
    Roller on what? This was posted under appliances. Garage door? Better explanation please.
    newly hung garage door, row four from bottom is forced out of track on both sides when opening

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Track lights that are compatible with hampton bay laser track? [ 0 Answers ]

I have hampton bay laser track and am looking for pendants and spots for it which makes are compatible

Out feed table saw PVC roller stand roller encaps [ 0 Answers ]

Some time ago I saw a set of fold up table rollers for use with table saw. These rollers were from 2in PVC pipe with molded end caps inserted into each end with a center pin into which each roller was inserted into oak rails. Thanks much, Wilson

Can I cut track lighting track (hampton bay) to custom length [ 1 Answers ]

I want to create a u-shaped layout for my hampton bay track lighting within a specifically defined space. To achieve this, I would need to shorten one track. Can the track be cut and maintain electrical continuity.

Cut opening in cold air return to allow alternative heat through forced air furnace? [ 4 Answers ]

I have a wood burning stove heating up my basement but the heat can't get to the upstairs because of the home design. I can't cut openings in the basement ceiling (upstairs floor) for the heat to just rise, so I am thinking about cutting a vent in the cold air return duct downstairs so I can just...

Garage door roller keeps slipping out of track [ 1 Answers ]

We installed a new garage door opener 2 months ago (the tracks were already in place.. installed in early 06 when home was built). When I open or close the door, the top roller falls out of the track. What would cause this to happen. It has been working fine until about 2 weeks ago. It was slipping...


View more questions Search