Ask Experts Questions for FREE Help !
Ask
    TerryPA58's Avatar
    TerryPA58 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 9, 2013, 07:07 AM
    Why am I getting pressure only but no water from the submersible well system?
    Replaced pressure tank that blew out, replaced pressure switch, replaced filtration system. Started the system and got nothing but pressure... no water at all! Even opened a water spiccet just off the "T" after bleeding of pressure, tried again... still nothing! Water was running great until system went down. Been down 13+ days now so need this fixed... HELP!
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Jul 9, 2013, 03:15 PM
    Questions:

    When you say you are getting pressure, do you mean your pressure gauge is showing pressure, or do you mean that when you open a faucet, you get a burst of air?

    If the pressure gauge is showing pressure, does it go up and down as you open a faucet? If not, then are you sure the gauge is not defective?

    The new pressure tank, is it a bladder tank?

    Are you certain the switch points are closing and the pump is getting current?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My water pressure has decreased in the last three days.Submersible pump at 385 ft. [ 1 Answers ]

In house water pressure goes down to almost nothing-good pressure at the well head of 40/60 always. Entire system is 20 years old. Pressure tank is suspected culprit or the switch may be worn bad enough to be an issue. Could the pressure tank bladder being bad cause this issue?

Submersible pump with low water pressure [ 0 Answers ]

Hi, I have well water with a submersible pump system. I have lived in my house for 7 years and just recently started experiencing low water pressure, and very low water pressure (to almost no water flow) after flushing toilet. I only notice this problem with the cold water. Can anyone tell me what...

How do I increase H2O pressure on well system with a water filtration system? [ 2 Answers ]

Howdy, I would like to know how I can increase my water pressure. My current system uses a well pump with a small pressure tank, and "D" control valve. It then runs through a WATERSOFT filtration tank, RAINSOFT water softner, and on the Hot water side, an AQUASTAR on demand hot water system. I...

View more questions Search