Ask Experts Questions for FREE Help !
Ask
    Dave Rounsavill's Avatar
    Dave Rounsavill Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 4, 2013, 10:05 AM
    No Running Water.
    I have a newer house with well and pressure tank. Was taking a shower when all of sudden no water. I checked the breaker and it was still on. Checked the breaker with D square next to the pressure tank and everything looked connected and no ants. The pressure tank seems to have no water in it. And pressure valve shows 0. There is a release valve near the pressure valve and when I open it water comes out easily. Any suggestions what problem could be?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Jul 4, 2013, 12:13 PM
    Reset the main breaker. With no pressure you should hear the pump rumning. If not, you need to check Voltage to the pump and across the pump control. If everything checks out you probably have a bad pump, possibly a foot valve. Is this an above ground or submersible pump?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Well water running light brown. Running cold water for 15 min. helped a little. [ 3 Answers ]

All my taps are running light brown. I have well water. I ran the cold water for 15 minutes and that helped a little. What should I do?

Toilet running over when tub water is running out [ 1 Answers ]

Why does my toilet run over every time the water is let out of the bath tubs?

Bathtub leaks only when water is running out of tub spout not when shower is running [ 4 Answers ]

Bathtub on 2nd floor is leaking to unfinished basement ceiling below. It only leaks however when the water (both hot and cold) is running out of the tub spout. It does not leak once the shower is turned on--nor does the tub leak when it's draining. Can anyone give a best guess exactly where the...

Bath tub shower spout & head running water running at same time [ 1 Answers ]

I started with a slight dripping problem(sayko system).i decided to replace all 3 stem assemblies together as they all were about 18 years old.after reassembling the new stems(danko brand),turned on the water supply & checked faucets.hot & cold worked fine but when the shower was turned on,water...


View more questions Search