Ask Experts Questions for FREE Help !
Ask
    vashmcl's Avatar
    vashmcl Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 29, 2013, 09:08 AM
    Replacement fittings for olmos toilet fittings
    I purchased a olmos push button toilet and now can't find fittings for inside the tank. Is there any other brand I can use to help this situation. I have become very frustrated, please help
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jun 29, 2013, 10:54 AM
    Depending on how old it is, you may be able to use a newer other brand tank. However, for $200 or less you can get a NEW American Standard, Mansfield, Kohler etc and not have to worry about obsolete toilet parts.
    vashmcl's Avatar
    vashmcl Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jun 30, 2013, 07:35 PM
    Thanks for your answer, I will be going shopping for the ones you suggested
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pex Fittings (shark bite fittings?) [ 6 Answers ]

Tom, Great advice I have been reading your responses and amazed with your plumbing experience! My question is that I used a 1/2 pex/sharkbite fitting to come off the copper supplies for a new shower, how do you feel about pex/sharkbite fittings? Its been in for about 8 months now, no problems.

Any exchange offer for toilet fittings nat B'lore? [ 0 Answers ]

I want to give away my bathtub,washbasin & a few toilet fittings as exchange for the latest models,is there any possibility?As my present fittings are pretty good not for discard but slightly oldfashioned.

Toilet Flex Line with brass fittings at both ends [ 1 Answers ]

My upstairs toilet flex line split at the plastic/nylon fitting underneath the toilet. We were out of town and the water ran for about four days. After three months of repairs to the house, I want to replace with flex lines that have brass fittings at both ends. I looked all over the internet and...

Rusty fittings [ 4 Answers ]

How do you prevent rust on the outside of steel and iron fittings?. both on the shelf and once installed? Would it make sense to coat them with mineral oil? Is there some other trick? Thanks in advance, Paul in East Troy WI

What's the difference in fittings [ 6 Answers ]

Can someone please explain the difference between dvw and water pipe as it pertaines to copper pipe fittings I asked this a while back and got one answer that was still a little bit vague , or more likely I'm still a little bit dumb! I think it has to do with the way the fitting s couple up as...

View more questions Search