 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
No water pressure from toilet valve
My toilet had been running constantly so I replaced the valve inside the tank.
After that, it stopped running constantly but every so often there'd be a running water sound and water would escape from the top of the valve (inside the tank, it never spilled over or anything.) I thought if I just redid the last few steps of the valve install I could stop that from happening, but now with the water turned back on the tank isn't drawing any water and when I remove the cap to the valve I can hear water running but its hardly even trickling out of the valve. How do I fix this? |
||||
Check out some similar questions!
First I had to replace the breaker for the water pump because the breaker must have went bad because I had no power to the pump. Fixed that and everything worked fine. I had to shutoff the water supply to repair a leak in a pipe. After I repaired the pipe I turned the water back on and got no water...
Hello. Cold water pressure relief valve start to drip water through the drain pipe. I replaced it with a new one but it is also dripping water. I have reduced water pressure in the house to the minimum by turning main water supply valve but it still leaking. Thanks for your help.
Toilet valve will not turn off water to toilet... keeps running
I have recently had a soft water installation put in. The shut off valve is conveniently close to the garage where the clean water tank was installed. Anyhow after the installation was completed pressure worked great in every room except the master bathroom toilet. The dual sink, the shower, and...
My plumber told me my water pressure is too high and is ruining my fixtures. Apparently my house is old and does not have these. Is installing these valves something I can do myself? The plumber wants to charge me $500.00. If so, where can I get directions? Help.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
