 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
My janitrol pump motor tries to start but just cut on & off without the motor going
In the air condition mode the heat pump tries to start up but turns on & off like flicking a light switch. A air conditioning service co. replaced a relay and it worked when he was here but on our first try with it after he left exactly the same
Problem returned. The same tech. came back & replaced the thermostat .It worked again when he was here .On the first attempt to use it after the second repair the same problem returned. My guess is that it's the run capacitor since the start up capacitor is hitting the start up winding with enough current but the run capacitor is not keeping it running. It's a Janitol unit but I don't know the Model #. [email protected] |
||||
Check out some similar questions!
It is a GMP-125-4 Inducer motor starts, I can see the igniter glowing and all the burners start for a few seconds. Then it shuts down the status light on the control board goes out. If I restart the furnace again right away the burners only light for a split second
I want to wire a bath room up flush toilet which is 5.3 amps motor into a curicuit with a 1500 watt wall heater ( 13 amps) on a 120 -20 amp breaker . The heater is never on and the toilet would only come on when some one uses down stairs bathroom.
What is Stepper motor & Servo motor and its working Priniciples,area of applications? Please give solution to me.
Hi I got this Janitrol Furnace it worked fine. Until my basement flooded then it looks like the circuit board got wet and it was on at the time. So basically I ordered a new board suppose to be coming soon. What happened was when the furnace came on like there were no flames only a bright...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
