 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Unplug the blower and wait five minutes... then replug and see if that allowed the unit to reset.
If that fails to work contact the manufacturer of the water heater (?) and talk to the people in tech. service department for specific testing procedures for their inducer... ;) Mark |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My inducer blower run hot is this OK back of inducer gas
I have a ruud furnace I just put a blower motor in and I put all the wires back as on the diagram on my furnace but the ignitor or inducer blower is not working now what can be the problem
This is so frustrating. We started noticing about a month ago that the blower on our hot water tank wasn't shutting off. The water was heating up just fine and the burner would shut off when it was hot but the blower would continue to run. Had someone out to look at it and he said it could be...
Replaced a hot water tank, turned the pump on and the water is bypassing the pressure tank. The pressure tank will not fill up and the pump remains on and will not shut off. We do get water though but needs to shut off the pump so it will not burn out. Any thoughts? Thank you Any ideas will...
I have an A.O. Smith H2O tank with a power blower vented out the foundation of the house. All the thermostat controls are electronic and the entire system was new in 2007 when we built our house. All of a sudden the led panel is lit up indicating system is in lockout mode? Possible solutions in...
View more questions Search
|
