Ask Experts Questions for FREE Help !
Ask
    Josh1994's Avatar
    Josh1994 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    May 9, 2013, 01:00 PM
    Riding mower problem
    I have a John deere gx75 and it will start right up but when I start to drive it it will still run till I get about 20 feet or less and it will die?
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    May 9, 2013, 05:48 PM
    Does it sound like its under a load , or running out of gas?
    Josh1994's Avatar
    Josh1994 Posts: 3, Reputation: 1
    New Member
    		  
    #3

    May 9, 2013, 06:39 PM
    Yes sir it sounds like its under a load
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #4

    May 9, 2013, 07:51 PM
    Check your air filter make sure its clean.
    Might try changing the spark plug also.
    Josh1994's Avatar
    Josh1994 Posts: 3, Reputation: 1
    New Member
    		  
    #5

    May 9, 2013, 08:08 PM
    Okay I'll try that an see thanks
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #6

    May 10, 2013, 03:46 AM
    HI Josh, you should also drop the bowl on the bottom of the carb to ensure it's clean. Good luck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Electrical Problem Murray Riding Mower [ 8 Answers ]

I was given a Murray Riding Mower that had nothing when the key was turned . I replaced the blade disengage safety switch and the mower started. I get nothing again when the key is turned. I replaced the cellenoid, battery, BDS switch again, and had the starter checked. The seat safety was...

Question about Craftsman riding mower problem [ 4 Answers ]

I just bought an older used Craftsman 917 series riding mower. The mower engagement lever is hard to move up into engaged position. When the mower lever is in disengaged position the blades keep moving steadily and will not stop. Is the mower belt too small? Too tight?

Honda riding mower problem [ 4 Answers ]

I have an older Honda 3011 Riding Mower that won't start without jump starting it. I just replaced the battery with a new one and I checked it with a voltmeter and it reads 11.8... I seem to remember car batterys usually reading 13+ so is this OK or too low? I have already checked the belts,...

Riding mower engine problem [ 2 Answers ]

I have a craftsman mower model number 917.258980 20.5 hp. My problem is that it will not start without the help of starting fluid. But right after the shot of fluid is exhausted it dies. The mower turns over good and yes I have gas in it. The fuel is getting to the carburetor, as I was able to...

Riding Mower Problem [ 1 Answers ]

My son has an old Lawn Chief riding mower that he purchased used. I finally got it started, but had to do so by shorting out the solenoid with a screwdriver to get it to turn over. Are any manuals available for these lawn mowers? The other idea I had was to put in a heavy duty push button...

View more questions Search