Ask Experts Questions for FREE Help !
Ask
    Thornbirds's Avatar
    Thornbirds Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 1, 2013, 04:42 PM
    . Burnt wires to block
    What is the sensor above the starter motor that goes into the block with yellow, red, black wire, it has burnt out and broken in block. Can you bypass this sensor by bridging these wires. Thanks Geoff
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    May 1, 2013, 07:40 PM
    Probably the solenoid. A pic would help, year and model?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heater relay burnt at wires on kenmore dryer 800 series [ 1 Answers ]

Why are wires burnt at heater relay

Electrical panel has burnt wires [ 2 Answers ]

Noticed 8 to 10 burnt wires on neutral bar in panel... possible causes?

How to hook up a new thermostat to furnace, 2 wires to a 5 block terminal? [ 0 Answers ]

Wiring , furnace block

I burnt eggs in a non stick pan and burnt the bottom how do I clean it [ 3 Answers ]

I burnt the inside botton of a non stick teflon pan while cooking eggs.what can I do to clean the pan

Burnt wires at the Run Capacitor [ 1 Answers ]

I noticed their was no hot air coming through my vents I checked the run capacitor and noticed the wires where burnt off one prong so I spliced the and reconnected. That worked fine for a week or so , this time two wires where burnt so I repeated the process and automatically the connection started...

View more questions Search