 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
1995 honda civic distributor
My honda civic, 1995, 160,000 miles, stalled at intersection. Previously it would rev while in idle position. My mechanic says he thinks it's the distributor. Engine lights on, won't turn over, ticks while turning start. What's up?
|
||||
|
||||
|
If the CEL comes on for 2 seconds and then goes out, when the ignition switch is turned to Position II, then focus on the distributor. Normally, replacing the Ignition Control Module (ICM) and coil solves the problem. Be sure to apply silicone heat transfer compound to the back of the new ICM; otherwise, it will shortly fail. If, instead, your mechanic replaces the distributor, only allow him to install a genuine Honda distributor--all others are junk, IMO.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Was driving today and my Civ just abruptly shut down. No bad noises or anything, just a shut down. It will not turn over, it just cranks and doesn't turn. AAA guy said there was no spark so it must be a distributor problem. From reading some posts it seems I should keep the distributor and...
In what order to I put the spark wires on back on the distributor?
I bought a used distributor part number td-41u 4m26 for my 1990 honda civic but the pllug-ins were different was it for a 1990 and can I change the ends to make it work
88 honda civic put water on engine now car lacks power could problem be distributor cap is wet what should I do
I have a 1999 Honda civic that wouldn't start. I paid $600 for a new distributor. The car has approx 48,500 miles on it. I have never had to replace a distributor on a car before. Is this a common problem?
View more questions Search
|
