Ask Experts Questions for FREE Help !
Ask
    KarenLadder36's Avatar
    KarenLadder36 Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 9, 2013, 11:18 AM
    Long water line
    I am going to attempt to run a water line 300+ feet from the meter. What size pipe do I need to use in order to have sufficient water pressure at the end of the run?
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
     
    #2

    Apr 9, 2013, 11:30 AM
    Would this be for a drinking fountain.. or an entire apartment building?

    As you can see... further information is needed.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #3

    Apr 10, 2013, 06:26 AM
    Yup! We need the fixture count (breakdown) to tell you more on this.

    We need to know the number of bathrooms (including number of shower heads and whirlpools, if present), 1/2 baths, washing machines, kitchen sinks, dishwashers, outside faucets, etc. If you leave any fixtures out it will effect the size requirement, so be complete in your answer.

    How far will the water heater be from the farthest fixture? If over 100 feet then you should probably be planning on running a recirculating hot water line, too...



    Mark
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #4

    Apr 10, 2013, 11:03 AM
    For a single family residence we run 3/4"{ PVC 1 inch should cover a duplex or 4 units. However on that long a run I'd run 1" PVC. Good luck, Tom
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #5

    Apr 10, 2013, 02:03 PM
    On run of 300' I would not go with anything smaller than 1 1/2" pipe, preferably with 2" pipe.

    Back to you / Milo
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #6

    Apr 10, 2013, 03:26 PM
    Please answer Marks questions. Also let us know what the water pressure in your area is. Lots of things go into correctly sizing water supply.
    marcusturner001's Avatar
    marcusturner001 Posts: 2, Reputation: -1
    New Member
     
    #7

    Apr 11, 2013, 06:17 AM
    If I may suggest, I think it is best that you consult a certified plumber to avoid costly mistakes.Big retrofits like this should be taken done with expertise and should never be done as a DIY project.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #8

    Apr 11, 2013, 07:01 AM
    Marcusturner said, "If I may suggest, I think it is best that you consult a certified plumber to avoid costly mistakes.Big retrofits like this should be taken done with expertise and should never be done as a DIY project."

    Sorry, MT, but you are wayyyyy off base here on a plumbing page where every plumbing expert is licensed for decades each! People come here looking for professional answers and when they give us the correct information they pull off some pretty amazing projects for DIY projects!

    Suggestions have been made above, but without the proper information it is only suggestions... not hard fact... why I asked for the information above!

    In fact, when (if) Karenladder returns she can clarify what size her water main is at this point and exactly what she is doing with this 300 foot run of pipe. Once the information is provided, we can help her set things up exactly as required in her area/state!

    Anyway, this is what we do around here, so she is consulting licensed plumbers... and doing it for free!! Not bad, huh??

    Mark
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #9

    Apr 11, 2013, 03:51 PM
    Well put, Mark. I second that, as Im sure all plumbers here do.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How much to put in a water line to a home - 1100 feet of new line? [ 3 Answers ]

The home is located in north central Arizona, and is about 1100 feet from an existing water line. The house is a 3 bed/2 bath home with normal water usage. I'm assuming using 1 1/2 inch pe or hdpe water line. The local water board sells meters for $600 and a turn-on fee of $35. How much on average...

Hard water line sputters - soft water line does not [ 2 Answers ]

Neighbor came over asking for help. They have soft water throughout the house and hard water to the outside spigots. I stood on their basement steps and watched as he turned on a spigot in the basement hooked to the soft water line and then he went outside and turned on a hose attached to the hard...

Getting good water volume for long water line run [ 1 Answers ]

I am planning to install water line on my farm. The water supply is coming from a 1hp submersible pump that is currently feeding the house with 1" PVC into the pressure tank. I am planning to run about 500" of 1" PVC down to a barn and from there another 1000" of 3/4" line out to some pasture. ...

Replaced Main Water Line, Now Shower Line Is Clogged [ 3 Answers ]

We had a leak, so we had the water line and sewage line from the house to the street replaced. Now we have no water in the shower. Some debris most have clogged up the line coming into the shower. All the other lines are fine. My Dad is somewhat of a handyman and wants to fix the problem...


View more questions Search