 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
These driers will do that when the lint builds up like concrete on the inside of the air ducts. Halfway cleaning it will not work. You need to totally tear it down and scrape out and wash all of the parts except the motor, which you vacuum out. You can go to YouTube to see videos on how to take it apart, but do a very good job or it will fail again quickly. I would get a new belt and change it while you have it apart and get some white lithium grease and grease any bearings you find. You need to clean out a drier every two years, at least, according to the manual. You just unplug the wires from the sensors and remove ductwork that they are attached on and clean the entire thing with soap and water. Make sure you go all through the dryer and get all parts like the blower fan and housing, vacuum out motor well and clean exhaust. Mark all wires you unplug so you know where they go. This is an easier job than you would think. Make sure to clean around all of the sensors, too, because when they cannot sense the dryer will not work, plus the burning lint deposits will burn down your house. See: Dryer vent cleaning prevents fires - YouTube and: Cleaning out a dryer with top lint cleanout - YouTube
Cleaning out a dryer: By a woman 2 of 2 - YouTube Manuals: https://dl.dropbox.com/u/8010163/Ken...%20Manuals.zip |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Six month old dishwasher. Worked fine until today - won't start. LIghts are on and control panel seems to be working OK. The "Clean" indicator is flashing in intervals of 7 flashes and then pauses. When I select the "Start" button it flashes red 3 times and then nothing. The "Drain/Cancel"...
I am experiencing weird problems with my top of the line Kenmore Elite Catalysts washing machine. I bought the washer and dryer as a pair for about $1700 in 1999. The dryer model # is 110.60936990 but the sticker has worn off the washer so I do not know the model #. I think it could be...
Timer seems to get stuck on 82 min. if you shorten cycle it stops on 39 min.
Would you please help me with the following issue? My washer is not draining, nor is it spinning. There is a lot of water collected at the bottom and I can't drain or spin? I try to restart it and it just beeps and rumbles for a couple seconds and then stops. Thank you so much in advance for...
The washing machine is not spinning, so I am attempting to replace the coupler. I am able to partially remove the front console, but I can not remove the main knob. I found instructions that say to hold the dial and turn timer knob counter clockwise, but this is not working. This should be...
View more questions Search
|
