Why did plumber seal doors on my super stanley after installing oil burner

joeg1 Posts: 2, Reputation: 1

New Member

Apr 1, 2013, 03:28 PM

Why did plumber seal doors on my super stanley after installing oil burner

After getting oil burner installed in super stanley range,plumber sealed all doors and lids. Why should he do this?

ma0641 Posts: 15,675, Reputation: 1012

Uber Member

Apr 1, 2013, 04:51 PM

Minimizes air leakage and increases efficiency of unit.

Add your answer here.

Check out some similar questions!

Best way to seal exterior doors [ 2 Answers ]

Hey all. I have 3 exterior doors, and 1 garage door. The exterior doors were not installed properly, and I've corrected as much as I can, without going to the trouble of rehanging. The doors are at least now fairly square. Plum is another problem however. I've added the foam...

Oil Burner still dripping.Oil Co. Tricks.fear for 3 dogs lives [ 8 Answers ]

That 1 you see as a response to my boiler question was to redirect my boiler question to heating and cooling. Please refer to boiler burner dripping below. Still need an answer as am not willing to have the tricky oil companies service my problem after causing it. They want to see more dollars...

Engine oil mixed with coolant after oil seal ring failure what next? [ 0 Answers ]

OK MY 97 jetta was spewing oil from above the filter cranked the car and the oil light came on. Checked the oil level and discovered antifreeze mixed in the oil. Is it a blown head or possible that d/t oil cooler o-ring failure that it leaked into the engine? Should I flush out oil and change...

Installing bypass shower doors and the shwer walls aren't plumb so doors have gaps [ 2 Answers ]

Cannot adjust shower doors to align correctly because shower walls aren't plumb... the shower bypass doors/rails etc are level and plumb but they leave gaps because the wall of the shower isn't plumb... any way to correct that enough to align the doors? Out of plumb appx 1/8 " on both sides. ...

Installing bypass shower doors and the shwer walls aren't plumb so doors have gaps [ 0 Answers ]

Cannot adjust shower doors to align correctly because shower walls aren't plumb... the shower bypass doors are level and plumb but they leave gaps because the wall of the shower isn't plumb... any way to correct that enough to align the doors? Out of plumb appx 1/8 " on both sides.