Ask Experts Questions for FREE Help !
Ask
    noidea1's Avatar
    noidea1 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 29, 2013, 07:07 AM
    Shower troubleshooting
    We have a Newteam 8.5kw shower which is losing pressue over the last few weeks( spray getting less) The temp setting has been the same since installation and this issue is a new fault. Checked mains water and this seems normal ta the taps. If temp settinf is lowere then the spray increases.
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #2

    Mar 30, 2013, 10:09 AM
    Did you try to remove the shower head and run water without it ? Is the pressure / water volume better ? Did you try to clean shower head ? ( there is a small filter screen that may be clogged up )..

    Back to you / Milo

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troubleshooting hot water cutting off on grohe shower mixer valves [ 1 Answers ]

I have grohe shower faucets and my bath.. I am having problems with the hot water cutting off when I take a shower.. could it be the shower mixer valves or could the temp. be set to high. I turned it down some but it still cuts off after a certain amount of time. I need some suggestions on what I...

Do we tile all of the shower walls even around the shower pipes then shower handle on [ 4 Answers ]

We are tiling around the tub do we tile all 3 walls then put shower handle and tub spout on walls or do we put tub handle on wall then tile around it?

Moen shower valve troubleshooting [ 7 Answers ]

I have two showers with the same trouble. After a few minutes the water gradually gets colder so you have to keep turning left to get hotter water. I changed both stems but still have the same trouble.

Troubleshooting drain problems on a shower stall [ 1 Answers ]

I have a fiberglass shoer stall that leaks water from under the stall but it only leaks when someone is in the shower it does not leak if you turn on the shower and stand outside, Oh it is installed on a raised platform on top of concrete. Thanks John

My shower drain is raised above the shower pan by 3/16" causing standing water [ 2 Answers ]

I have a fiberglass shower stall where the bottom has either slumped or the stall was installed wrong to begin with (it has no support beneath the surface that I stand on). The drain sticks above the level line so I have about 3/16" of standing water. I cannot easily access the bottom from the...


View more questions Search