Ask Experts Questions for FREE Help !
Ask
    jlbull25's Avatar
    jlbull25 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 15, 2013, 03:52 PM
    How to remov solenoid on briggs and stratton 287707 1255-e1
    Hav not tried to remove solenoid from carburetor. Cannot see if there are flats for a wrench or if I should rotate float bowl. Thanks for amy help. JLB
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Mar 15, 2013, 06:54 PM
    Looks like it has flats on it to me.
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs stratton 14 hp ohv I/c quiet model 287707 repair manual [ 1 Answers ]

Need to rebuild a briggs 14 hp I/C Quiet Engine Model-287707 Type-022002 Code-9309084A The Engine was run dry on oil but now it runs fine at high trottle but at low trottle it puffs white smoke and backfires every now and then should I put new rings in it or is it the head gasket and if it is does...

Need a wiring diagram for a 14.5hp Briggs and Stratton model number 287707-0224-01 [ 0 Answers ]

Need a wiring diagram for a 14.5hp Briggs and Stratton model number 287707-0224-01. Looked on the Briggs and Stratton site, was unable to find. Thanks in Advance

Solenoid Test for Briggs & Stratton engine [ 2 Answers ]

Hi, I have a 9hp Troy Bilt walk-behind mower with electric start that only clicks when I turn the key. I had the battery load-tested and it is fine. I took the solenoid to a local repair place and they tested the solenoid and said it was fine. But, after talking to a neighbor, he suggested...

Briggs and Stratton Solenoid Wiring 14.5 HP Single Wire [ 1 Answers ]

Would like some help in securing the correct connection of the red solenoid wire (single) to the proper wire on harness from chassis. It is a 14.5 HP BS being wired to a Sears Chassis. Thanks in advance.

Briggs & stratton 14 hp 287707 backfires [ 2 Answers ]

New key on flywheel. Has spark. New sparkplug. Carberator cleaned thoroughly. Set fuel mix needle at 1 1/2 turns out. Installed new drive and starter drive. Adjusted valves. Cleaned valves and piston face. Still backfires out filter housing and exhaust. What are some solutions?

View more questions Search