 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Water heater pilot problems
Thake you I been trying to light my water heater which I turned off 5 years ago. I can get the pilot to light but when I leave go of the bitton I have been holding down for up to 5 minutes the pilot goes out . I though it was the thermal so I replaced it and I have the same results what's rong
|
||||
Check out some similar questions!
Our pilot light keeps going out on our gas hot water heater. I am able to relight it and the burner fires up but hours later we notice no hot water and the pilot light is out again. Help? What shall I try?
I have a State Select Water Heater, I am assuming the pilot light has gone out as I have not hot water. What process do I do to see if this is indeed the problem before calling in a service man.
I have a 2 year old sears water heater and there seems to be a lot of flaking going on from somewhere inside and this causes the flame to go out. If I clean it out the water heater works fine for about 3 mo. And starts all over again. What causes this to flake? Thanks!
My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...
Pilot went out, no problem relighting. BUT when I turn up the thermostat, the flame gets out of control and escapes from the two protective doors. It has started melting the plastic on the outside of the tank around the drain valve.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
