Ask Experts Questions for FREE Help !
Ask
    chcdette's Avatar
    chcdette Posts: 2, Reputation: 1
    New Member
     
    #1

    Feb 18, 2013, 11:11 AM
    Whirlpool Dishwasher won't complete the cycle.
    I have a Quiet Partner ll Whirlpool dishwasher. It will fill up but when it is time to wash it makes a buzzing sound and stops. I can push cancel/drain and it will drain the water out. It always fills as if it is going to wash then buzzes and does no more. It is about 2 years old.
    chcdette's Avatar
    chcdette Posts: 2, Reputation: 1
    New Member
     
    #2

    Feb 19, 2013, 10:57 AM
    I have fixed my problem. I removed all the parts inside the dishwasher until I got down to the chopper. The chopper had bits of glass from a broken cup preventing the chopper from working. I removed all this glass and other debris and put it back together. It works!

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool washer wtw4800XQ0 after wash cycle is complete leaves clothes still wet [ 1 Answers ]

Wtw4800xq0 model whirlpool leaves clothes too wet after wash cycle completely done. Darren

Ge dishwasher won't complete cycle [ 0 Answers ]

I have a ge profile D/W, model gsd4230x66ww. It used to sometimes run complete cycle and others stop advancing during rinse cycle. Now will not complete cycle at all. Any thoughts? Thanks for any input, Dennis

Furnace won't complete ignition cycle [ 3 Answers ]

My furnace won't complete the ignition cycle. York Furnace Model: P3UCD12N07601A Updraft Here are the steps when the furnace attempts to ignite: 1. Exhaust fan and igniter turn on. 2. A little while later the gas comes on and ignites. 3. After about 2 seconds, the igniter goes off...

Whirlpool dishwasher only runs quick rinse cycle [ 2 Answers ]

My Whirlpool dishwasher only runs the quick rinse cycle no matter which button is pressed. I have changed the electronics board and tried two different user interface boards. Any ideas? Or does anyone know where I can get a schematic for the interface board? Thanks, Tom

Dishwasher won't go through complete cycle [ 1 Answers ]

Hi, I have a kitchen aid dishwasher model kudc25chss1 about 7years old, it won’t complete a cycle, it fills up runs for a second, empties out and repeats the same was for the next cycles. Before I replace the processor board I want to know if it could be another problem. Or is it in the processor...


View more questions Search