Furnace

fmartinjr Posts: 1, Reputation: 1

New Member

Feb 17, 2013, 12:15 PM

Furnace

I have a Oneida Royal Air 80u Furnace that does not always ignite the burner when calling for heat. Could I have a circuit board failing? I noticed the high voltage lead comes right off the circuit board.

Check out some similar questions!

How to wire my greentek hrv to kicks on the furnace fan on low of a heil furnace? [ 0 Answers ]

How to wire my greentek hrv to kicks on the furnace fan on low of a heil furnace? I had a airconditioner installed in August and for some reason they unhook my hrv so now the hrv turns on but doesn't request the furnace fan to come on. So now it's not circulating the air in my house properly. I...

XB80 Gas Furnace , furnace fires up fan turns on but no airflow in ducts [ 0 Answers ]

Furnace fires up just fine, and fan spins but there is absolutely no airflow in duct work. Any ideas? Last spring thermostat went out and I replaced it, worked great. A month later circuit board burned out, tech found that problem and replaced it (major pocketbook ouch) and everything worked...

Bryant furnace showing code 12-blower on after power up. Furnace won't start. Why? [ 0 Answers ]

Blower motor on all the time. No heat from furnace. Why?

Furnace Blower Motor Runs Constantly & Furnace or AC Won't Run [ 2 Answers ]

I have an Armstrong forced air (induced draft) natural gas furnace with central AC (made around 1990 -- Model: EG6H80DC14-1, Serial: A18315MNA). I had a problem at the end of the heating season where the blower motor would run continuously (even when the thermostat is turned to "off"). I thought...

View more questions Search

Check out some similar questions!

Add your answer here.