Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
What would cause multiple element failures in a dual element electric HWH?
[ 1 Answers ]
We installed a 100 gallon dual element water heater tied to a whole house circulation system and have had 4 heating elements (both upper and lower elements) fail in the 6 months after installation. Could the problem be from the circulation pump having a short into the water, grounding to the...
Burnt red wire to the heating element to hot water heater. (electric).
[ 2 Answers ]
Burnt red wire to the heating element. Cover has been off after I replaced the heating element 18 months ago. I did have this problem about two months ago when it appeared that the red and black wire touched each other . There was the burnt smell and melting. I cut off the burnt parts and...
How to change a four prong stove cord to a three prong oven cod
[ 0 Answers ]
I have four prongs on my stove I need to change it to three prongs I need to know how to connect the wires
Electric wall oven bake element wire
[ 5 Answers ]
Hello Thinking I was on a roll after rewiring my ceiling fan I decided to replace the bake element on my kenmore electric wall oven that died the other night-how hard could it be to do? I turned off the breaker-unscrewed the element and gently pulled it out. One side had the wire attached-one did...
Three prong dryer element
[ 1 Answers ]
I have a friend that has a dryer problem. First the breaker was shot. I replaced it. Next the thermoswitch was shot. I replaced it. Now I only get 110 too all three of the dryer connections. I cannot get 240 across these connections. Am I too assume this dryer has two elements since there are... View more questions Search
|