Ask Experts Questions for FREE Help !
Ask
    Dean1956's Avatar
    Dean1956 Posts: 2, Reputation: 1
    New Member
     
    #1

    Feb 16, 2013, 04:21 AM
    Two blinking red lights, not running, open pressure?
    My furnace is not running. Two red lights are blinking meaning "pressure open". What does this mean and how do you fix it?
    Dean1956's Avatar
    Dean1956 Posts: 2, Reputation: 1
    New Member
     
    #2

    Feb 16, 2013, 04:38 AM
    My gas furnace is flashing two red lights saying "pressure open". What is this and how can I fix it? Do I need a professional?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #3

    Feb 16, 2013, 08:33 AM
    One of your pressure switches is not working. Open the front of the unit, at the burners, and look for a round disc with a plastic or rubber tube. Make sure it is unobstructed. You may have also have a partially obstructed vent pipe, especially if you have a 90% heater. Your inducer fan may not be working. It supplies air pressure to close the switch. If you know nothing about heaters, suggest you get someone to look at it.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What do five blinking red lights mean on a xe80 trane furnace [ 1 Answers ]

I have a XE80 furnace (installed sept.1995) the light blinks five times. The thermostat is off but a fan motor comes on that can be heard at the return vent.

Goodman Furnace - 3 Blinking lights, solid light w/suction on hose to pressure switch [ 2 Answers ]

Hello, I have 3 blinking lights on a Goodman GMNT080-4B gas furnace. An online manual says this is caused by "PRESSURE SWITCH FAILURE TO CLOSE" and to check: "VENTER, PRESSURE SWITCH, VENT BLOCKAGE". One potentially useful bit of diagnostic information is that if I suck on the hose going...

Open pressure switch with inducer motor running [ 0 Answers ]

I have 3 flashes when the furnace shuts off inducer is still running.When it shuts down wait a few min and the furn. Comes back on again.Is this normal operation?I do have a drain opposite side of the inducer.Is that on the wrong side of the furnace.Concord 95.

Diagnostic lights indicate pressure switch open because of reduced flow [ 1 Answers ]

My Carrier furnace is not starting for the first time this fall. The Diagnostic lights indicate pressure switch open because of reduced flow. Is there a re-set switch or some way to diagnose this problem. Is it possible there is something blocking flow? What can I do with this? In researching...


View more questions Search