Ask Experts Questions for FREE Help !
Ask
    John Stinson's Avatar
    John Stinson Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 15, 2013, 08:24 AM
    Electrical questions answers
    What are the consequences of using an AC voltage rated switch and wire for DC voltage rated equipment on a very small load 12 volt DC automotive windshield washer motor?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Feb 15, 2013, 08:27 AM
    None that I can think of.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #3

    Feb 15, 2013, 09:58 AM
    Only real issue is when you put high loads through it. Contacts get pitted. However, for what you are needing, should be OK.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Electrical questions and answers [ 4 Answers ]

I'm replacing a 240 baseboard heater with a 240 1500 watt baseboard heater. The original one was wired with 10-3 600 wire on a 30 amp circuit. Can I replace the 10-3 600 wire with 12-3 300 wire?

Electrical questions and answers [ 13 Answers ]

I am reading 120v to my ceiling fan (where fan connects to ceiling) even when the switches to the fan are in the off position. I have check all wiring connections and they seem to be fine. I have been in this house for 7 years with no problem. Can't figure this one out. How can it have electricity...

Electrical questions answers [ 2 Answers ]

My mother lives in an older house. Some of the outlets are wired with 14/2 w/earth gnd (3 pronged outlets). Some are wired with 14/2 w/o earth gnd (2 pronged outlets). My mother uses a lot of "cheater plugs" (adapts 3 pronged cords to 2 pronged outlets). This leaves the appliance cases...

Electrical Questions Answers [ 1 Answers ]

Whole house 200amp generator with transfer switch do the neutral and ground wires for the circuits in panal box have to be separated

Electrical questions answers [ 1 Answers ]

I'm remodeling the kitchen and putting in new appliances . Im putting a 220 line in for a double oven where the refrigerator once was. The outlet where the oven is going is a 4 x 4 box with 1/2" EMT from the breaker box. Two questions: 1. Will 1/2 " EMT accomidate two 8 gauge hot wires...

View more questions Search