Ask Experts Questions for FREE Help !
Ask
    HANDY WANNABE's Avatar
    HANDY WANNABE Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 27, 2013, 07:41 AM
    State select electric water heater
    I have a State Select electric water heater (M/N ES630DOLSG) that was not heating water. Then I was told A/C on top wet the electrical component and tripped the circuit breaker. Now its all dried out and breaker stays on but no water when faucets are turned to hot water side... all faucets and dishwasher not having any water. How do I reset? So the water heater will fill with water to heat and distribute? Thank you thank you
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Jan 27, 2013, 11:22 AM
    Did someone close the cold water input valve to the water heater?
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #3

    Jan 28, 2013, 09:18 AM
    Turn off power and re-do wiring because it must have burned a wire in two. That would be the common sense approach. Also, check the water valves. You may need to clean it out. They fill up with sand and scale and should be cleaned out before they quit working.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

State select electric water heater [ 2 Answers ]

I have a State Select electric water heater (M/N ES630DOLSG) that was not heating water. Then I was told A/C on top wet the electrical component and tripped the circuit breaker. Now its all dried out and breaker stays on but no water when faucets are turned to hot water side... all faucets and...

Troubleshooting state select electric water heater? [ 1 Answers ]

My State Select Electric Water Heater Model # PR650XBPDTD; Serial #: F04423256... won't ignite. I replaced the Ignitor assembly and it continues to give me the same error code on the temp panel: far left green light and the A & B are yellow. Please Help!

State select electric water heater [ 1 Answers ]

Hey Speedball1, I have a State Select water heater that the reset button has to be pushed every morning. It is the red button on the water heater its self. Sounds like a common problem with this heater. What do think is causing it, and how do I test to be sure? And where do I get a...

State Select electric water heater [ 1 Answers ]

The water heater has keeps shutting off but will restate when reset button is reset, what is wrong:

State select electric hot water heater [ 1 Answers ]

I have a 4 yr old State Select electric hot water heater that is recently starting to trip the red reset button. Model #es652sort. It is set at the factory setting of 120 degrees. Could this be a thermostat problem and if so, what are the solutions? Thanks and I look forward to your response.

View more questions Search