Ask Experts Questions for FREE Help !
Ask
    chewkelley's Avatar
    chewkelley Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 22, 2013, 05:28 AM
    Furnace troubleshooting
    I have a two zone boiler system, one zone is turning on and off when not being called by the thermostat. My furnace is running constantly because of this. I changed the batteries in that thermostat what else can I do before I call someone in?
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Jan 22, 2013, 05:18 PM
    I would start by unhooking all t-stat wires from both zone valves (make sure to write them down so you can hook them back up correctly). And see what happens. Let us know..

    PS. Make sure the power is off the system when dealing with the wiring.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace troubleshooting [ 3 Answers ]

How do I locate my furnace relay switch?

Furnace troubleshooting [ 2 Answers ]

What's wrong when my furnace starts blowing hot air then stops and shoots out cold air... then when I check the thermostat the temp went down by itself...

Furnace troubleshooting [ 0 Answers ]

I

Ask troubleshooting a furnace? [ 0 Answers ]

The flame goes around the burner what would do this?

Furnace troubleshooting [ 1 Answers ]

I have an amana furnace about 20 years old. Model #ghi115a35. When I put the thermostate at 70 or 75, does not matter, the inducer motor comes on, the glow light is on, the gas valve will open, but will not ignite the burners. Then the gas will close, I try again, about two times, then the gas...


View more questions Search