How to figure header size for garage door

RegP Posts: 1, Reputation: 1

New Member

Jan 10, 2013, 01:36 PM

How to figure header size for garage door

How to figure haeder size for a 16' garage door.

creahands Posts: 2,854, Reputation: 195

Ultra Member

Jan 10, 2013, 01:57 PM

welcome to AMHD,RegP

Double 2 x 12 with 1/2'' plywood in between. You will need double jack studs on each side.

Chuck

Add your answer here.

Check out some similar questions!

Should I frame a wall on outside of garage door, leaving garage door in place? [ 5 Answers ]

I would like to convert the garage into a workroom by putting up a frame on the outside of the garage door, insulating it and leaving the garage door in place so that if I need to sell the house I can convert the room back into a garage. What problems could arise and are there any...

How do I syncronize my remote control garage door pad with my garage door [ 1 Answers ]

Can anyone tell me how I can syncronize my remote control pad to open the garage door from the car?? I recently reset my code on the panel, because I didn't know the original code and now when I drive up in the car, my remote contral pad does not work to open the garage door... Any possible...

Garage door header [ 1 Answers ]

I am framing in an existing pole-barn carport. Framing is 2x6 and designed by an architect. The architect's notes just said to ""Frame down existing header" over the two garage doors without additional details. I take it this is because the walls are not load-bearing - the goal is to just bring...

How do I sync the keyless pad garage door opener to the main garage door opener? [ 3 Answers ]

I mistakenly gave someone my garage door opener that didn't return it. I had a male friend come over and "change the code" including my car opener and gave me a universial which he also programmed. I came to realize my code for my keyless pad outside doesn't work (since he changed the code... )....