Ask Experts Questions for FREE Help !
Ask
    Frederick Paul's Avatar
    Frederick Paul Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 6, 2013, 03:35 PM
    How do I dissconnect my Flame Sensor / Payne PG8UAA?
    How do I disconnect My Flame sensor and clean it?
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Jan 6, 2013, 05:55 PM
    Hi FP

    Here is a link to the furnace manual:

    http://www.gogeisel.com/geiselonline...as_Furnace.pdf

    The flame sensor is at the bottom left of the gas manifold and should be obvious on how to remove it once you locate it!

    Use some steel wool to clean the end and reinstall... should resolve the issue if this is indeed the issue!

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

A wire came undone on my old payne heater. Blower goes but now no flame from t-stat [ 0 Answers ]

I was cleaning the front. There are two wire connections. I think I pulled one of the wires out of one of the connections. The blower still goes but the thermostat doesn't give a flame since that wire became disconnected. Does it matter to which one of those wire connections I reconnect this...

Location of flame sensor on Payne furnace PG9 [ 2 Answers ]

Location of flame sensor on Payne furnace PG9.

Payne flame proving [ 2 Answers ]

My four year old Payne 90% efficient furnace fails to retain its flame and shuts down. The LED code says that the problem is in the Flame Proving circuit. The recommendation is for cleaning or replacing the "probe". I have done both with no success. This seems to be a common problem with...

Flame Sensor [ 5 Answers ]

How can I replace a flame sensor in a Trane heating unit?

View more questions Search