 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
My Carrier gas pack 48GS will not reignite after it reaches temp.
After reaching desired temp, my Carrier unit 48GS will not reignite unless the power to it is cut and then restored. We have replaced the gas valve and thermostat already. There was some rust inside the unit that burning off and was causing a foul odor. After removing it, the odor dissappeared. I was told that I may have a clogged heat exchanger... Can this too be cleaned out , or do you have to replace it ?
|
||||
Check out some similar questions!
What is the procedure for changing the heat exchanger on a Carrier 48GS Gas Pack
On my 48GP036090311, the main fan (that moves air through the ductwork, not the condensing unit fan) began to run constantly, even with the T-stat disconnected. Don't see any evidence of physical damage in the control panel section. Is this a relay failure, or something in the controls?
I have looked at the circulation fan and it is working. I have a contractor putting a room addition on the house and the problem started when they were moving some duct work. The return trunk was disconnected and moved. They did not connect it completely and the circulation slowed then stopped. ...
When switching from summer to winter my carrier gas pack is not producing heat. Is there a pilot light that can go out
I have a Carrier gas-pack Heating/Airconditioning system (about 12 years old). A few weeks ago I noticed the heating cycle was not working. I ran some checks to determine the cause and discovered that the main circulation fan was never coming on when the fan was set to the "Auto" position. The gas...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
