 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
70deg. Db outdoor temp.62degdb/58deg. Wb indoor temp. Suction press. 62psi, head pres
70 deg. Db outdoor temp. 62deg db/58deg. Wb indoor temp. suction press. 65psi, head press. 195psi, evaporator temp. drop 20 deg. Compressor superheat 16 deg. Is the unit udercharge, good,overcharge
|
||||
|
||||
|
With a 20 deg drop across the evap coil, you are doing good. However, if this is a residential ac system, the inside temp may be out of range for the charts available. It really all depends on the equiptment and many other factors. Only real answer will come from an onsight professional.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My temperature gauge keeps redlining then dropping below normal operating temp. I had my thermostat replaced, still happens, flushed rad and added head gasket repair (liquid) and ran as directed heater on full. Tenp gauge stays low while driving with lots of heat but when idle at light temp gauge...
Several times I have noticed that the thermostat reads current temp as 12 degrees above what it is outside, is this right as there is nothing on at the time in my house producing heat? Is my thermostat faulty or does my house hold heat? Example temp outside 64f temp in my house 78f. I don't...
I'm putting goldfish in a pond and need to make sure the temp is adequate for their survival. The room is a approx 30 x50ft 20 ft ceiling. The amount of water is the only thing I'm unsure of, but it's approx 30-50 gal.
Hello, This is my first time posting here, but I figured it was a good place to start for some advice. I just bought a new townhouse a few weeks ago and have been having some heating issues since moving in. The actual furnace (Goodman GMS 8045) was installed in June of '06 while the unit was...
I have a 2.5 nordyne heat pump at 40 deg I read 58 psi on the suction and 165 psi on the disc with a liquid temp of 90 deg register temp 88 deg.charging chart calls for 51 psi suc 164 psi disc and a liquid temp of 160 deg. 2 yr old 13 seer first season for heating. Ac mode all is fine. ...
View more questions Search
|
