 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Cycles burner and blower a few times before going to off status.
I have a Lennox G26. I have noticed lately being home all day for the holidays, The furnace seems to cycles on and off, about every 3-4 minutes, sometimes longer, sometimes shorter. (burner and blower motor), a few times before changing the system "on"status on the thermostat back to off. It also comes back on a and does the same thing about 10 15 minutes later. Temp on the thermostat still shows the set temp. I would only expect the furnace to start again once the temp dropped 1 or 2 degrees.
|
||||
Check out some similar questions!
Blower motor in my Goodman furnace will not shut down. Staus light blinks 4 times, can't find anything to tell me what the status codes are
I have a Keeprite NTC6075FBG1 that's about 8years old,It starts up ventor motor first then the burner lights then the blower motor start,after a few minutes of being on blowing heat the burner goes out, nothing else stop just the burner goes out, then about 45 second later the buner relights and...
I have a 4 year old Goodman heater model GMS81155CNA that we just replaced the blower motor on, fortunately it was under warranty until April. Now it keeps trying to cycle 2 or 3 times before the burners actually go on, sometimes it will ignite on the first attempt other times it won't. Often we...
I have a Goodman GPM075-4, the blower stays on all the time. The status led flashes 5 times, TS guide inside panel says "false flame detected", "stuck gas valve". Is there a way to bypass or verify this state?
I have a Carlin hot air oil fired system. The burner appears to short cycle when the stat calls for heat. Once the stat calls for heat the burner fires up and runs for a few minutes after the fan comes on. Then the burners shuts down for a few minutes while the fan still runs and fires up again....
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
