Ask Experts Questions for FREE Help !
Ask
    speeedy65's Avatar
    speeedy65 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 4, 2011, 06:58 PM
    3 position switch for WZT 1000 Regent Portable Worklight
    My Regent WZT 1000 portable work light was knocked over and the 3 position (250, 500, off) push button switch was broken. I am unable to locate a replacement switch for the unit.
    zxcqwe789's Avatar
    zxcqwe789 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Dec 22, 2012, 05:51 PM
    Still interested? Send me an e-mail at [email protected]. I have the same model which had a ceramic lamp holder break. I can not locate a replacement lamp. The switch works perfectly.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New Ceiling Fan switch Won't Go to Off Position [ 2 Answers ]

Replaced switch on Hampton Bay ceiling fan (3 speed - 4 wires). Attached wires identically as on old switch (L-Black, 1 Gray, 2 Brown, 3 Purple. Fan will change speeds, but will not turn off. The switch is from Home Depot (Westinghouse brand). Am I doing something wrong?

Wiring portable generator to xfer switch, specific questions [ 1 Answers ]

Applicable code is 2011 ICC. Trying to correctly set up a portable generator inlet box (4 wire twistlock) and run almost 20 ft through a finished garage to the transfer switch (which is mounted next to the main service panel). The intended genset is 7kw, 110/220v, and has integrated 30A...

Light switch trips itself in off position fed from breaker to switch to outside light [ 1 Answers ]

Swapping Dual Light Switch for Dimmer/Three Position Switch for Ceiling Fan [ 1 Answers ]

I am trying to swap out a dual switch for a switch that has a dimmer for the ceiling fan light and a three position switch to control the fan. The original wiring had white to white on switch, black to black on switch, and one black from light connected to the top switch pole and the other black...

Can't move switch out of Pilot position [ 2 Answers ]

We are trying to light the pilot light on the gas furnace. The switch won't move out of the "Pilot" position. If the pilot lights and stays lit - is there a danger in leaving it on "Pilot"?

View more questions Search