Ask Experts Questions for FREE Help !
Ask
    dfuller0227's Avatar
    dfuller0227 Posts: 77, Reputation: 1
    Junior Member
    		  
    #1

    Dec 22, 2012, 04:33 PM
    How to reassemble a 93 honda accord valve rocker arm that came completely apart
    How to reassemble a 93 honda accord valve rocker arm that came completely apart. I took the rocker off to change the seals because oil was coming threw the seals but when I took the rocker off and out the arm completely fell apart and I have know idea how to put it back together could someone please help
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Dec 23, 2012, 06:45 AM
    Get a Shop Manual, or equivalent, which will allow you to easily put it back together. You will need this for the torque, tightening sequence, and valve adjustment.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rocker arm came loose [ 5 Answers ]

I have aDR lawn vacuum, was running then stopped.I found the intake raocker arm came loose. I put it back on and it runs like a champ. Is there something I have to adjust or fix so it doesn't happen again?

2004 Honda Accord EX Control Arm Replacement [ 0 Answers ]

I have a 2004 Honda Accord Ex with damage to the rear passenger wheel. All 4 control arms are bent. I have installed all new Honda OEM arms and wheel is still not alighned perfect. I did not realaize I needed to mark on of the control arms so the bolt goes on the correct way. I believe I have it...

2000 Honda Accord Alarm does not arm [ 1 Answers ]

Hello I have 2000 Honda Accord EX 4dr 4cyl The problem I am having is that when I lock the doors, the buttons lock, however the alarm does not arm. The horn is supposed to beep, lights flash, and the led on the drivers door should blink. This is what happened for all the years that I had the car....

B&S Rocker Arm Adjustment [ 1 Answers ]

I have the specs for clearance on my OHV system. It is a Briggs and Stratton 14.5 OHV I/C motor. I am trying to get the rocker arms adjusted properly. I have never done this with the type nuts that we have on here. In the middle of the nut, there is a setscrew used for the adjustment. Could someone...

Rocker Arm Bolt Stripped [ 1 Answers ]

I have a B&S 14.5 OHV and the rocker arm bolt is stripped. Does anyone know what size the thread are that go into the cylinder head? I am hopefully going to try and match a helicoil and retap the threads. Dang aluminum! Thanks in advance! If you have any other suggestion I could try, it would also...

View more questions Search