[garylbailey80]

I heard the humming noise again and saw interferince on the TV. The fan stopped moving again, Now the fan don't run at all anymore. The lights are the only thing working. I also notticed the fan was shacking more with the med then more with the high speed setting. The way the ceiling was wired was a black wire, white wire, and the ground was screwed down. I did red remote to black ceiling, white remote to white ceiling, green hanger to other screw on the other side of ceiling ground. Then one the remotes other side I did blue wire to blue fan, black remote to black fan, white remote to white fan, and green fan to green hanger. I need to know if I wired it corectly and how to fix the shacking, All the blades are straight. This is my first time doing this. Please help. The ceiling fan is an aloha breeze 52 inch.







Than you;

Gary

[ballengerb1]

Most of the shaking is due to improper balance of the blades. You can buy a very inexpensive balance kit at the store and try it yourself. If any blade is warped or too far out of balance you might need to buy a complete set of replacement blades. Check each blade for a tag that states the weight. They should weigh the same. I apologize but can't asnwer your wiring issue since I had difficulty following your description. On the surface it sounds fine but I suspect your have some Rf interference or a bad receiver.