 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Hello, I have a bryant 75 342 heater,been working great for years and now won't ignite
Hello, I have a bryant 75 342 heater,been working great for years and now won't ignite.The pilot lights and stays lit, the fan comes on with the thermostat but doesn't ignite... it uses propane any thoughts?
|
||||
Check out some similar questions!
System is calling for heat. The draft inducer comes on, the hot surface ignitor gets red but burner won't light. I ohmed out the gas valve and it is good. I cleaned the flame sensor with soft sand paper.the IFC has a constant light on the board. What could b the problem?
Bryant furnace automatic pilot won't turn on?
My dad had a Bryant Plus 80t gas furnace installed a couple of years ago. He's having some home improvement work done in the basement where the furnace is. The walls were bleached while the furnace was running. The fumes went throughout the house, so I turned the thermostat off and aired out the...
Hi, My furnace starts fan, pressure switches activate, gas valve turns on, but ceramic ignitor is not glowing. I changed the ignitor and no improvement. I measured the voltage on the plug with the ignitor disconnect during startup and only got 8 volts AC. Does this indicate that the control...
Bryant gas furnace fails to ignite. LED displays code 34: Ignition proving failure. Hot-surface ignitor glows, but I never hear any gas. The main gas line is open. Gas hot water heater and another gas furnace work fine, so gas is likely OK. I assume that because the flame never ignites that...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
