 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Af80 aire flo gas furnaces
I have a AF80 Aire Flo Gas furnace and I would like to be able to run the blower fan continuously on low speed... then when the furnace fires run on high speed... Is this possible with this model?
I did try hooking the G terminal at the thermostat to the G terminal on the furnace panel and the blower ran on high speed... also by moving the black wire from the heat terminal to the cont terminal the blower ran at high speed... Thank you |
||||
Check out some similar questions!
Aire-Flo AF90MPE075 - on a call for heat the combustion blower runs, pressure switch closes, his glows and gas valve opens for a split second. Sometimes the inrush of gas is not enough to even ignite and sometimes it is enough to ignite across the burner but then goes out immediately. Again, this...
We have a stewart-warner 'saf-aire' gas burning room heater and I would like to know if there are any manuals and parts to repair them anywhere in existants. Thank-you for any help with this matter
I have an Aire-Flo Furnace ( Model AF90MPE075U3). Last winter it began malfunctioning. The local repair man said the inducer fan was bad and replaced it. It worked for a while and began acting up again. He then decided the intake air line was to small and not sloped properly. I added a second line...
I have a armstrong ultra furnce 90% installed in 1992 are the new furnaces with same rating anymore Efficience now?
I have an Aire-flo model AF80 forced air furnace that is not putting out any heat. The blower is working fine. I have tried the circuit breaker and replacing the thermostat but neither seems to work. Anyone have any suggestions?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
