York ignition problem

Check out some similar questions!

York furnace ignition lockout on retries [ 0 Answers ]

My york furnace is flashing the 7 code, ignition lockout due to retries, what can be the cause of this?

I installed a S9200U1000 furnace control on my york.both blower coming on no ignition [ 1 Answers ]

I installed a S9200U1000 Furnace control on my york furnace.My induced blower and circulator blower are coming on at same time and my H.S.I is not igniting.I checked my limit switch and rollout switches,both are working. What could be the problem

York forced air heater with electronic ignition troubleshooting [ 5 Answers ]

I have a York forced air gas fired heating system with I guess a direct ignition instead of a standing pilot light. When the system comes on, the blower comes on and then a couple of seconds later the gas valve clicks and some gas goes through but no ignition. Then the gas valve clicks again but...

York 80 Furnace ignition goes off when blower comes on [ 12 Answers ]

I have a York Diamond 80 furnace Model# P4HUAR12N03201A. New construction 05 installation. Went away from this house for 2 months. Came back and furnace won't operate. System ignites, heats up plenum, blower comes on, and then the fire immediately goes out. Has a component failed or has the 2...

York furnace - No ignition,no heat [ 4 Answers ]

I have a York Gas Furnace (model# P2MPD14W08001B, 12yrs old) giving out no heat. I did basic troubleshooting and realised system was not igniting; replaced ignitor (changed original 4-5 years ago) - fired up initially and then went out after running for about 30 minutes. I cleaned the flame sensor...

View more questions Search

Check out some similar questions!

Add your answer here.