 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Late ignition on gas furnace.
We have a gas heater used to heat a small home. The burner will take a while to catch once the gas is supplied, causing a loud "bang" as it ignites. It sometimes will also make a loud whooshing sound for a few seconds when it catches. We've also had the pilot go out unexpectedly once or twice. We vacuumed out the burner and it helped a little, but we still have the problem.The thermocouple has been replaced before. What else should we be doing?
|
||||
Check out some similar questions!
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
Ignitor in york diamond 80 seris furnace won't turn on
Furnace model GNJ075N12C1. Electronic ingition module: SV9500M2682 Furnace works fine most of the time... then enters the start up mode with no light off and locks out. I have found that if I 'giggle' the ignitor connector in the control module the resistance ignitor comes on, temporary pilot...
Hello I have a old lennox OF3 80C, the problem is it belches smoke from the inspection port in the fire box at ignition, it fills the chimney to the point where it will shut down. We put a brand new nozzle in and new in-line filter and the furnace will run now but it still belches even after up to...
I have a Bryant, Day & Night, gas furnace model 394GAD which approximately 20 yr old. It works fine except for wasting gas due to the manual pilot continuously lit. I would like to install a automatic ignition system. Does anyone have any experience with this? Do you know the model number, etc....
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
