Gas Furnace & no electricity

ThisIsAV Posts: 1, Reputation: 1

New Member

Nov 3, 2012, 11:15 AM

Gas Furnace & no electricity

How do I jumpstart my Weil-McLain gas furnace using my water heater

Grady White Posts: 1,417, Reputation: 59

Ultra Member

Nov 3, 2012, 02:56 PM

With no electricity, you don't.

Add your answer here.

Check out some similar questions!

No electricity [ 3 Answers ]

Our bathroom light switches work fine. The electrical outlet next to the switches doesn't seem to have any electrical power. The circuit breakers are correct. This all happened after an extremely close hit of lightning to a palm tree on our property. A few other outlets also stopped working, but...

Forced air furnace lost electricity [ 0 Answers ]

Electric furnace has been burning fuses, now it has no elcetricity at all.

Electricity [ 2 Answers ]

I live in South Africa. I bought a dual output generator 6.5 Kw 360/220 volt some time ago.One 220 volt outlet and one 360 volt outlet. It was only later that I discovered that the 220 volt side only gave me about 1.9Kw.Is there a way that I can get the full output (6.5 Kw) at the 220 volt side....

Electricity 480 [ 0 Answers ]

Problems with measurements. The question is: confirm that electrical motor will be adapted to 400 vac 50Hz. The answer from USA is: the electric is 480 three phase electric and 60 amps. Manual also says 460 v, 3ph and 230v, 3ph (optional). Does any of these measurements match the measurements in...

How do you test a gas valve in a furnace for electricity? [ 1 Answers ]

My good man furnace will start the igniter will ignite but the burner do not produce flame I think my gas valve is not being activated by the circuit board therefore no gas is being release. How do I test for this I am getting a 2 flashes in the code but the pressure switch is fine. Help!