Ask Experts Questions for FREE Help !
Ask
    rob7548's Avatar
    rob7548 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 28, 2012, 10:44 PM
    Rough Plumbing in 8 inch block wall
    I need to run plumbing drain and water lines in a 8 inch block wall for the purpose of roughing in wall hung urinals, lavs, and floor set flushometer type water closets. What is the best method to do this, am I going to have to be there while the wall is being built?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Oct 29, 2012, 06:09 AM
    The first part of your post gave me the impression the wall was already built until I read this.
    am I going to have to be there while the wall is being built?
    If the water and drainage \'s already in place and stubbed out the block masons don't need you on site when they build the wall. They know what to do. Good luck, Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have 11 inch rough in ,from the wall to the bolt center, [ 1 Answers ]

What is the right rough in measurment should I use in this situation to replace the old toilet?thanks

How do you install an iron lintel in a cinder block wall after cutting the wall open? [ 0 Answers ]

I plan on cutting & opening 7' tall x 8' wide in an existing cinder block wall 8"x8"x16" that was laid with a stack bond (joint on joint). How do I insert an iron lintel 1/2" thick x 4" wide x 8'6" length? The length of the lintel is planned to go beyond the width 3" on each side. Is that enough...

Pouring a concrete wall in front of a damaged cinder block wall [ 1 Answers ]

I need to repair a well house that has buckling cinder block walls. The well is below ground with a shed above it. The room is approximately 9' x 8' and 8' tall with cinder block walls and a concrete floor. The block did not have concrete poured in it when it was built, the blocks are beginning...

9 inch rough in [ 3 Answers ]

Hi, I am remodeling an older home the original owners put an addition on that included a half bath in the new utility room. The rough opening from the sheetrock to the center of the flange is 9 inches without chipping concrete out and putting in an offset. Is there anything else I can do to...

Plumbing lines in concrete block outside wall [ 1 Answers ]

We are in the process of planning a bathroom remodel. The shower has 1/2" supply lines that are located on an outside wall. There is no way to use an inside wall. We want to make the shower into a custom shower with body sprays, rainfall head, hand held spray, and maybe a ceiling spray. With...

View more questions Search