Ask Experts Questions for FREE Help !
Ask
    mustanggt's Avatar
    mustanggt Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 17, 2012, 10:32 PM
    American Standard/Trane - the heat exchange clogged this outside unit
    I have american standard trane heating unit . The heat exhanger pipes clogged in front burners . The heat exchanger pipes don't have screen over it but some type clay inserts atached by clip there is 1 for each pipe what is this part never incounterd bfore this unit made1997 it is ycc model outside unit
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Oct 19, 2012, 09:46 AM
    You have a high efficiency heater. One tube is for intake air, the other for exhaust
    Very common to have mud wasps put their tubes in there. Clean out the mud, lightly flush with water and put hardware mesh, 1/8" over the ends.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Are Trane/American Standard HVAC systems top quality? [ 3 Answers ]

I've been reading reviews and people are saying Trane HVAC units are Pieces of s***, is that true? I always thought Trane/American standard systems were top quality and were better than Carrier. I personally like Carrier as my #1 choice. So witch is the best Trane or Carrier?

I have an american standard central gas heat when it call for heat I get 4 flashes in [ 0 Answers ]

Unit blower comes on but no heat the light on control board flashes 4 times pause then 4 times again when system is calling for gas these flashes indicate that a can anyone help? Icannot find reset buttons on my unit.

Fan on 1992 American Standard (Trane) doesn't work . Model # YCC018F1LOBA unit comes [ 1 Answers ]

1992 gas/electric heat pump fan will not blow. Model #YCC018F1LOBA

Had a new 2 1/2 American standard a/c unit installed [ 1 Answers ]

For most of the day the unit is quiet,until much later in the day,then a vibration noise begins,& gets louder. Sounds like a pipe vibrating,but appears the 3/8" copper line is clearing. The unit is 6 inches away from the Wall,& instructions state 12 inches to prevent overheating. Any help...

American standard/trane furnace blower won't shut off . [ 0 Answers ]

Blower won't stop and burners not fireing.blower doesn't respond to thermostat control.tested pressure switch ,cleaned sensors,good filter.I'm not getting any trouble codes either , please help. A/C workes fine but blower still dosen't stop.

View more questions Search