Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Carrier furnace: limit switch fault furnace has ignition but blower will not come on?
[ 2 Answers ]
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
Bryant furnace showing code 12-blower on after power up. Furnace won't start. Why?
[ 0 Answers ]
Blower motor on all the time. No heat from furnace. Why?
Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset
[ 5 Answers ]
I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...
Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks
[ 3 Answers ]
I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.
Add on coal/wood furnace thermostat wiring for 2 zone house with oil furnace
[ 1 Answers ]
I purchased a Harman wood / coal furnace model SF-2500 (forced hot air system) and am tying into my existing forced hot air oil furnace 2 zone system and do not know how to tie into the existing thermostats and zones. I wish to still use the 2 separate zones for the bedrooms and the main body of... View more questions Search
|