Ask Experts Questions for FREE Help !
Ask
    Wiley_15666's Avatar
    Wiley_15666 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 3, 2012, 07:44 AM
    Craftsman 5 horsepower tiller
    I have a craftsman 5 horsepower tiller about 25 years old. I've been told it probably has a Tecuseh engine in it. Where would the serial number be on the engine?
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Oct 3, 2012, 09:11 PM
    Hi,
    It is probably stamped into the top of the blower housing and possibly covered by othe parts. When you find a number beginning with 143 it is a Tecumseh and I can cross it for you.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman 5 hp tiller briggs and stratton engine - tiller won't start anymore [ 8 Answers ]

Craftsman 5 HP Briggs and Stratton tiller front tine model 917298352 I bought it yesterday. It is approx 4 years old and was only used twice. I put some gas in it and it started quickly. Ran fine for about 30 minutes and then started revving up and down and then eventually died. I could...

Old Craftsman Tiller Parts [ 0 Answers ]

I am searching for a part no longer carried by sears for their reat tine tiller. Model # is 247.298780 and Part # is 06800. This is the tine shaft. Any suggestions on where else to search?

I have a 17 horsepower tractor (craftsman) that starts and runs but stops after a few [ 0 Answers ]

I have a 17 horsepower tractor (craftsman) that starts and runs but stops after a few minutes then takes a while to start then does the same thing over and over

Craftsman tiller motor [ 0 Answers ]

I just want a simple yea or no answer and how to get it! I have a 7 hp craftsman tiller and the motor gave out. I just want to know the price and if they even sell JUST the motor! Any help would be appreciated.

Craftsman Tiller [ 2 Answers ]

I have purchased a new carb already. 5.5 hp B&S. I think I damaged my old carb by using air pressure to clean out the old gas. The rubber seat under the needle came out and there is no way to get back in. Can this be repaired?

View more questions Search