Ask Experts Questions for FREE Help !
Ask
    clark321's Avatar
    clark321 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 26, 2012, 07:12 AM
    Honeywell Model RTH7600
    Recently purchased and installed today. Referred to manual for clock settings. Followed directions and did the following. Pressed clock and other, set time and pressed done. Cannot determine how to move to the month day, etc. The instructions in the manual do not go beyond setting time other to mention using go back etc, but this takes you back the clock and more. How to I get to more.

    Also if I do not want to use the leave program do I program leave the save as my day and sleep times to prevent it from engaging?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Sep 26, 2012, 07:25 AM
    This link will take you through it step by step, https://customer.honeywell.com/resou.../69-2206EF.pdf Good luck, Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

RTH7600 Honeywell [ 0 Answers ]

Why does the thermostat run for 1 minute every 10 minutes on the heat cycle?

Replacing Lennox 51h4301 with a Honeywell RTH7600 [ 3 Answers ]

Looking for the wiring match-up to replace my existing thermostat 51H4301 to a Honeywell RTH7600 unit. My outside unit HP21-511-4P and the inside unit is CB19-51-3P-TXV. The current wiring for the thermostat is: O G C R T W1 - two tied together on one screw Y1

Honeywell thermostat rth7600 manual [ 2 Answers ]

I currently have a Honeywell T841A1217 and want to install an RTH7600. The wiring labels are different. T841A1217 has W2,X,O,E,G,Y,R. The RTH7600 has C,G,Y,O/B,RC,R,AUX,E,L. The RTH7600 also has C,G,Y,W,RC,R,W2,Y2. I have a 2.5 ton Carrier Heat Pump.

Honeywell RTH7600 thermostat [ 11 Answers ]

I have a honeywell RTH7600 thermostat. The inside temperature on the termostat says it is 4 degrees higher than the room actually is. It says it is 78 degrees and it is actually 74 degrees. Is there a way to calibrate the thermostat to show the true temperature?

Honeywell RTH7600 Battery Free Operation [ 2 Answers ]

Hi, I successfully installed the RTH7600 on my 2 wire Weil McLain, hot water, cold start, gas fired system. I then tried to enable the battery free function by running the system common wire (C on the 28vac transformer) to the "C" terminal on the thermostat. This did not work. Should the common go...

View more questions Search