Ask Experts Questions for FREE Help !
Ask
    Decho1961's Avatar
    Decho1961 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 24, 2012, 08:32 AM
    Obd 95 civi del solo
    How do I check the check engin light
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Sep 24, 2012, 09:02 AM
    Service Check Connector (SCC): Reading OBD-I Codes

    When the Check Engine Light (CEL) is on, it will be necessary to locate the 2-pin Service Check Connector (SCC) on OBD-I (pre-1996) Hondas. It is normally located under the dash, approximately 1 inch (2.5cm) from the right kick panel. Take a small screwdriver and carefully pry it from the rubber mount. The other 3-pin connector in the rubber mount is the Data Link Connector (DLC), which should be left alone. Jump the SCC with a paper clip, turn the ignition switch to ON (Position II), and count the number of times, if any, the CEL flashes. Reference a Diagnostic Trouble Code (DTC) chart to identify the code being displayed. The SCC is also jumped, when an induction timing light is used to check engine timing.

    After troubleshooting, turn the ignition switch OFF, remove the jumper wire, and reset the ECM, by removing the BACK UP (7.5 A) fuse from the under-hood fuse box for 10 seconds.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do I respond to a civi action summons, from another state [ 0 Answers ]

I received a Civil Action Summons from a Attorney.regarding a lawsuit to foreclose the mortgage on my property located in Osceola County Fl.They are asking for a response. Please advise what kind of response I would send. Since I live in NYC. I am not sure what to say.

Honda civi si engine turns but won't start [ 1 Answers ]

I have a 2000 honda civic si I was going down the road and it stop on me.when I went to started up again the engine turns over put won't start . I ck and fund there no spark at the spark plug. Can someone help me

Can a P1615 OBD code cause a P0335 OBD code [ 1 Answers ]

2004 Maxima won't start after battery was disconnected for 5 days while tranny was being replaced. Turns over fine and dies. I get a P1615 NATS Malfunction code (security system issue) and a P0335 Crankshift sensor circuit problem. Is the 1615 issue causing the P0335 issue or does the crankshaft...

Civi case pending [ 1 Answers ]

One of my creditors decied to file suit and when their lawyer contacted me they told me that the debt is two years and when they filed suit they marked that the debt is 4 years. How can they mark the suit for 4 years and then tell me it is 2 years before. When you are served with a summons are you...

View more questions Search