Ask Experts Questions for FREE Help !
Ask
    kaylagohring's Avatar
    kaylagohring Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 20, 2012, 01:31 PM
    Why would my philco furance goes through its cycle, then shuts off blower kicks on
    Why would my furnace goes through its cycle , even ignites for maby 4-5 sec then shuts down and the blower kicks on the model is a philco model# kg6rc
    Thanks kayla
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Sep 20, 2012, 03:28 PM
    why would my furnace goes through its cycle , even ignites for maby 4-5 sec then shuts down and the blower kicks on the modle is a philco model# kg6rc
    thanks kayla

    Try cleaning the flame rod with sand paper or steel wool.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My h/ac unit, Philco, blower does not sinc with the gas burners when on [ 0 Answers ]

I have checked, cleaned everything and was told from Philco that my mother board is bad... they said that is where the blower motor relay is and to replace the part is $300. My blower motor does not sinc with the gas burner.. comes on after the gas goes off most of the time. Any suggestions where...

Blower motor kicks on of a few seconds then shuts off [ 0 Answers ]

I have an Armstrong air techV 80 unit. I tried to turn on the heater the other day and it didn't work at all. The air had been working fine all summer. I replaced the smart valve thinking that would solve the problem. Well, now the heater works but even when the theromostat is OFF the inducer...

My furnace makes one cycle then blows the trasformer when the blower shuts off! [ 1 Answers ]

I have an older Rheem furnace. I had a tech. out two weeks ago and he replaced the blower, circuit board, limit switch, and capacitor. One week ago the transformer went, I replaced that with a used one and it blew that one immediately. Went out today and bought a new one (put that in along with two...

Furance shuts off before themostat temp is reached [ 1 Answers ]

Hi, I have a new two stage variable speed lennox furnace, G61V-60C-091. Due to some heating problems right after the install, the company I hired also installed a new white-rodgers programmable thermostat 1F78. Unfortunately even with the new thermostat, I'm having the same problem. At 6:15am,...

View more questions Search