Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Honeywell RLV430 installation
[ 14 Answers ]
Ok, this is similar yet different to a previous topic. I'm trying to install the Honeywell RLV430 to replace an older dial thermostat. The original thermostat has 2 black wires, one white, and a bare copper going to it. My first observation is that there is no place for the bare copper wire...
Honeywell rlv430 thermostat
[ 1 Answers ]
I hooked up the unit (honeywell rlv430 thermostat) (it had been in storage, in original packaging for 4 years) and get nothing appears after the power is turned back on. The wires are live (I checked that), is there someway to determine if the unit itself is bad or to reset it so it might work?
No Display on the Honeywell RLV430
[ 2 Answers ]
We are trying to install a RLV430 to replace an older model of a Honeywell thermostat and there is no display on the LED. We even purchased another thermostat (same model) because we thought the first was defective but we're experiencing the same issue on that one. The wall has a black and...
RLV430 Honeywell Thermostat
[ 3 Answers ]
I am trying to replace my old manual thermostat for a programmable Honeywell RLV 430. I have two base board heaters to hook up to the thermostat but not sure what wires to match up to.
Thermostat Honeywell RLV430
[ 1 Answers ]
The Manual says that this thermostat can only be used with a resistive load over 2A . Is there any way this ca be change to use it for a furnace heating system ? Not resistive ? Thanks View more questions Search
|