 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Installing Hanger Bolts
How do you install a hanger bolt into wood,without messing up
The threaded that will take a nut? See picture |
||||
|
|
|
||||
|
Put two nuts on the end... tighten then against each other and they will lock tight enough the outermost nut can then be used with a wrench to thread it in... and the nuts come off just as easy after its in.
|
||||
|
|
|
||||
|
I use Smoothy's method or run an acorn nut over the thread. Easier to screw down since you don't have to align the flats.
|
||||
|
|
|
||||
|
Very good
|
||||
|
|
| Question Tools | Search this Question |
Check out some similar questions!
I bought the FluidMaster toiler repair kit and replaced all my toilets in the house. 2 of them are okay but two are leaking a drop once in a while through the bolt. I did follow the bolt installation instructions. Also tried to tighten it more but no luck. Any idea how to fix this? Is there...
Hanger bolts zinc worked just fine. Now I wonder being outside in the element That the threads may get corroded. Maybe I could spray them with a rust inhibitor. Or use those protective caps. Any ideas
What kinds of hanger models are available for plumbing? I was told to implement one into a faucet system by an inspector and would like to know the appropriate model applicable here.
My shower/tub drain has always been problematic, but I usually fave fair warning before it gets too bad. This time there was no warning. I took a shower on Wednesday and everything was fine, took a shower on Thursday and BAM it won't drain. Now its Saturday and there is still water in my tub. I...
View more questions Search
|
