 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I'm replacing my old three wire condenser fan motor with a new four wire fan motor. The capacitor is a dual run cap with three terminals. The old wires were red (goes straight to T2 on the contactor), brown/white (goes to cap), and black (goes to fan terminal on a circuit board, which I think is...
Motor has four wires yellow, black, brown, and brown with white sripe. The od motor only had three wires black,red and brown. On the new motor I hooked the yellow to L1 the black to L2 and the two brown to fan on the dual cap. The motor starts, runs but it gets very hot and shuts off after a few...
Central air system turned on, condenser fan and compressor not running. Reset button is tripped. Press reset , contactor closes compressor motor starts, condenser fan does not start. 20 seconds later reset trips shutting down compressor. Same result even after letting sit overnight. Old Williamson...
My Fan blade assembly was bent when I replaced my Fan motor!! Grainger has them for $55 dollars and the $92 dollar one looks like my origanal,does it matter and How do I factor in the pitch.I guess I need to find a counter person that knows about that? Whereas Grainger support is by phone. ...
Hey guys I have a rudd heat pump. Needed to change the motor . I had difficulty getting the fan blade off, so I took it to the local home improvement center to have the fan blade taken off with a puller. Now it seems like the heat pump is out of center when I start the motor it shakes like an...
View more questions Search
|
