Ask Experts Questions for FREE Help !
Ask
    ddhdds's Avatar
    ddhdds Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 25, 2012, 06:06 PM
    Replacing impeller on a j10s gould jet pumps
    Have gould j10s jet pump, that is not putting out much volume and taking a long time to reach shut off pressure, is it most likely time for a new impeller?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Aug 27, 2012, 06:13 AM
    is it most likely time for a new impelle
    Only a pump guy can tell you that and only after he opens up the pump.
    There are other things besides a bad impeller that could cause your problem but until you open up the pump you'll never know. Good luck, Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to build a jet engine impeller [ 1 Answers ]

I need to make a jet engine impeller and I am unable to find it so please sugest me how to build it by welding, not by leathe

1/2/HP craftsman jet shalllow well pump only pumps to 25 psi & won't shut off. [ 3 Answers ]

My pump pumps to about 25 psi & won't get any higher. Holds it's prime. PSI switch is per set to 40/60 & new. Air in tank checked around 25 when -0- psi on gage. Pump is maybe 3 years old. Thanks

Jet ski impeller [ 9 Answers ]

I know this is a sight for cycles, but hope you can help me out. I just bought a couple used jet skis and the impellers are gouged up pretty bad. Ive been told that you can file the edges until they are smooth again, and there is a chance it will cure the no go problem. Is this true. Is it...

Deep Well Jet Pumps : Are Ejectors/Venturis model specific? [ 1 Answers ]

Howdy, I am planning to replace a 25-year-old deep well jet pump, and really can't handle the expense of converting to a submersible at this moment in time. Above-ground pumps are available for a couple of hundred bucks, and I think I can manage the swap myself *IF* I ca keep the job to replacing...

Replacing heat pumps - The choices are overwhelming [ 3 Answers ]

I am relacing 2 Carrier/Cobra heat pumps for my dual zone, 3,400 sf house near San Antonio, Texas. I have talked with three service/contactors, the opinions, recommendation and pricing are all over the board. From a cost/value perspective, I am settled in on a 14-15 SEER system. Also, the...

View more questions Search